
C3 User Guide
22
Cable routing option 1: Bottom entry
• Remove the Solar Enclosure from packaging and assemble to mount via
tabs, the enclosure need not be held in place once on the mount (Figure
9, follow sequence 1-2)
• Extend the solar panel outward slightly and open the enclosure door
• Remove the hardware pack
• Place the enclosure on the mount (Figure 9) and secure using the small
thumb bolt and washer supplied in the hardware pack (Figure 4-6)
• Extend solar panel out to the desired angle (see appendix A3), lock in
place by tightening large thumb screw (Figure 4-1)
• Install the large M32 cable gland supplied in the hardware pack into the
bottom entry hole, noting that the seal should be on the outer face of the
enclosure (Figure 4-8)
Cable routing option 2: Rear entry
• Select a drill with a diameter to suit the cable being used
• Drill one or both cable entry holes through mount/pole/wall using pilot
marks in mount as a guide (Figure 7-3)
• Feed equipment cables up pole and through holes made above
• After pole has been secured, remove solar enclosure from packaging
extend solar panel outward slightly, open door and remove hardware pack
• Drill one or both cable entry holes in rear of solar enclosure using pilots
marks and 16 mm drill or hole-saw (Figure 8-2)
• *OTUBMMUIFTVQQMJFEQJFSDFUISPVHIDBCMFHMBOETçBUTJEFGBDJOHPVUXBSE
(Figure 8-3)
• Feed cable through cable glands as the enclosure is being assembled to
the mount
• Place the enclosure on the mount (Figure 9) and secure using the small
thumb bolt and washer supplied in the hardware pack (Figure 4-6)
• Extend solar panel out to the desired angle (see appendix A3), lock in
place by tightening large thumb screw (Figure 4-1)
• Install the M32 plug supplied in the hardware pack into the bottom entry
hole, noting that the seal should be on the outer face of the enclosure
Comentarios a estos manuales