DAVIS CarChip 8210 Guía de usuario descargar pdf (Pagina 23)

Normalize Vertical Speed Axes

You can configure the Trip data plots to use the same vertical axes by enabling "Normalize vertical axes to ___

mph (kph, m/s)" in the Setup / Plots dialog box and entering the speed

To show set the vertical axes in the vehicle speed plots:

1. Choose Plots from the Setup menu. The Setup / Plots dialog box appears.

2. Click on the check box next to "Normalize vertical axes" to toggle the function on and off. A check

indicates that the function has been enabled.

3. Enter the desired value for the vertical axis in the edit box.

4. The maximum allowable vertical axis speed is 158 mph, 255 kph, or 70.8 m/s.

5. The maximum recommended vertical axis speed is 100 mph or less.

6. Choose OK to save the new plot setup. Choose Cancel to exit the dialog box and retain the previous

plot setup. Choose Apply to make the change without exiting the dialog box.

Note: You can call up the Plots setup dialog box and change the vertical axis while viewing the plots.

Plot Coordinates Options

You can see the plot coordinates of your cursor position either by pressing the Ctrl key when this function is

enabled, or, by disabling this function. When plot coordinates are displayed, you will see the time and data

values for the current cursor position inside the plot.

To show plot coordinates only when the Ctrl key is pressed:

1. Choose Plots from the Setup menu. The Setup / Plots dialog box appears.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 60 61

Sin comentarios

DAVIS CarChip 8210 Guía de usuario Pagina 23