DAVIS DriveRight OBD II Guía de instalación

DriveRight OBDII Installation Guide

8Top of Dashboard Mounting Using Brackets or Velcro™Sun Visor Mounting 2. Insert the battery into the DriveRight console.Pan Head Self-Tapping ScrewSp

93. Connect the DriveRight console cable to the adapter cable. Note: To disconnect the cables, hold the both cables by the connector housing and pull

10Appendix 1: OBDII Compatibility Use this list to verify the compatibility of your vehicle’s OBDII port with DriveRight OBD.Supported OBDII Protocols

11Technical SupportIf you are experiencing problems with your DriveRight, first check the cable connections and verify the calibration settings. If yo

12Installation Notes:

13Installation Notes:

14Installation Notes:

FCC Part 15 Class B Registration WarningThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to P

1IntroductionThis manual provides instructions and information necessary to install the OBD version of the DriveRight 600E device. The DriveRight OBD

2CablesWiring ComponentsAdditional DriveRight DocumentationRefer to the following documents for information on configuring and using your DriveRight:•

3Installations using Adapter Cable Digital InputsIf you are using the adapter cable digital inputs in your installation, the following additional tool

4Wiring DiagramThe diagram below is an example of DriveRight OBD wiring. Procedure 1: Connect OBD Cable to OBDII Port.1. Locate the OBDII port in the

5Look in the follow areas if you have trouble finding the OBDII port: • Under the dash• In front of the passenger seat• Behind the ash tray• Behind a

61. If you are installing a DriveRight 600E OBD but not using the digital inputs, go to Step 10 of this procedure.2. Butt splice the red fuse holder t

77. Use the in-line butt splices to connect the blue wires with fuses to the Green (Digital Input 1) and Yellow (Digital Input 2) wires from the adapt