Davis Anemometer Transmitter Kit Manual de usuario descargar pdf (Pagina 9)

Mounting Transmitter Shelter on a Pole

1. While holding the

shelter against the

pole, place a U-bolt

around the pole and

through the two

holes on at the top of

the shelter.

Flat

Washer

Lock

Washer

Hex

Nut

U-Bolt

2. Place a flat washer, a

lock washer and a

hex nut on each of

the bolt ends.

3. Using an adjustable

wrench or

7/16"

wrench, tighten the

nuts.

4. Place the second U-bolt around the pole and through the two holes at the bottom of

the she

lter. Put a flat washer, a lock washer, and a hex nut on each bolt end, and

tighten the hex nuts.

Note: Remember to position the shelter so the solar panel has maximum exposure to the sun.

Mounting Transmitter Shelter on a Vertical Surface

1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a

carpenter’s level to ensure the holes will be level.

2. Drill two more holes 7-

1/32" belo

w the upper

holes.

Flat

Washer

Lag

Screw

3. Insert the 1/4" x 1-1/2"

lag screws through the

flat washers, and through

the holes at the top of the

shelter into the post.

Using an adjustable

wrench or 7/16" wrench,

tighten the lag screws.

4. Insert the 1/4" x 1-1/2"

lag screw

s through the

flat washers, and through

the holes at the bottom of the shelter into the post. Using an adjustable wrench or

7/16" wrench, tighten the lag screws.

Note: Remember to position the shelter so the solar panel has maximum exposure to the sun.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Davis Anemometer Transmitter Kit Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los termómetros Davis Anemometer Transmitter Kit