Davis Anemometer Transmitter Kit Manual de usuario descargar pdf (Pagina 8)

8

3. Swivel the

anemometer until

the arm is pointing

north, if possible.

U-Bolt

1/4" Flat Washer

1/4" Lock Washer

1/4" Hex Nut

4. Using an

adjustable wrench

or 7/16" wrench,

tighten the nuts. If

the anemometer

arm is not pointing

north, calibrate

your console by

following the

instructions in your

console manual.

Mounting Anemometer on a Vertical Surface

1. With a 3/16" (5 mm) drill

bit, drill two holes

approximately 2-1/8" (54

mm) apart. Use a

carpenter’s level to

ensure the holes will be

level.

1/4" Flat Washers

1/4" x 3" Lag Screw

s

40' of Anemometer Cable

2. Insert the 1/4" x 3" lag

screws through the flat

washers and the holes in

the mounting base into

the post.

3. Using an adjustable

wrench or

7/16" wrench,

tighten the lag screws. If

the anemometer arm is

not pointing north,

calibrate your console by

following the instructions

in your console manual.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios