DAVIS Sensor Mounting Arm Manual de usuario descargar pdf (Pagina 6)

Page 6 Sensor Mounting Arm

Attaching the Anemometer Below the Sensor Arm (Preferred)

To attach the anemometer below the sensor arm, you will need the anemome-

ter, sensor arm, two 1/2” U-bolts, two 1/2” saddles, four 1/4” ﬂat washers,

four 1/4” split lock washers, four 1/4” hex nuts, one cable clamp, one #8-32 x

3/4” screw, one #8 ﬂat washer, and one #8-32 hex nut.

NEMOMETER

TTACHED

ELOW

ENSOR

1. If necessary, disconnect the anemometer from your weather station.

Your weather station manual contains instructions for connecting the two.

Simply reverse the directions to disconnect them.

2. If necessary, disconnect the anemometer arm from the anemometer base.

Your weather station manual contains instructions for connecting the two.

Simply reverse the directions to disconnect them.

3. Place one of the 1/2” U-bolts over the anemometer arm.

4. Slide one of the saddles over the end of the U-bolt so the anemometer arm is con-

tained in the circle created by the U-bolt and the saddle.

LACE

U-B

OLT

AND

ADDLE

NEMOMETER

5. Repeat this process for the other 1/2” U-bolt and saddle.

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Sin comentarios

DAVIS Sensor Mounting Arm Manual de usuario Pagina 6