Davis Vantage Pro2 Temperature/Humidty Sensor Replacemen Manual de usuario descargar pdf (Pagina 4)

Disassemble the Radiation Shield — Temperature/Humidity

Station

Note: We recommend using a workbench or table to perform the following procedures.

1. Place the Temperature/

Humidity Station on a

level surface.

2. Loosen the three

mounting screws that

hold the mounting

bracket and the

radiation shield

together.

3. Separate the radiation

shield plates to locate

the Temperature/

Humidity sensor in the

plating. See “Remove

the Previous

Temperature/Humidity

Sensor” below for

instructions on

removing the previous sensor.

Remove the Previous Temperature/Humidity Sensor

1. Locate the Temperature/Humidity sensor on the second to bottom plate in

the radiation shield plating stack.

2. Remove the three screws and flat washer securing the Temperature/

Humidity sensor to the radiation plating.

Mounting

Bracket

Radiation

Shield

Assembly

Lock Washers

Flat Washers

4" Screws

Cable Clamp

emperature/Humidity

Sensor

1 2 3 4 5 6 7 8

Sin comentarios

Davis Vantage Pro2 Temperature/Humidty Sensor Replacemen Manual de usuario Pagina 4