Davis Vantage Pro2/Pro2 Plus: Temperature/Humidity Stati Manual de usuario descargar pdf (Pagina 9)

2. Next, install the SIM Shelter. With a 3/16" (5 mm) drill bit, drill two holes approxi-

mately 2" (50 mm) apart. Use a carpenter’s level to ensure the holes will be level.

3. Drill two more holes 7-1/32" below the upper holes.

4. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through the holes

at the top of the shelter into the post.

Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

5. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through the holes

at the bottom of the shelter into the post.

6. Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

Note: Review the illustration below to see how the Temp/Hum Station is mounted on a vertical surface.

Mounting on a Vertical Surface

1/4" x 1-1/2" Lag Screws

1/4" Flat Washers

1/4" Lock Washers

1/4" x 1-1/2" Lag Screws

Sensor Cable

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Davis Vantage Pro2/Pro2 Plus: Temperature/Humidity Stati Manual de usuario Pagina 9