Davis Alarm Output Module Manual de usuario descargar pdf (Pagina 10)

Page 10 Alarm Output Module

✦

Selecting between normally-open and normally closed operation

If you select normally-open operation, each of the four alarm outputs

will close when the alarm connected to that output is active. If you select

normally-closed operation, each of the four alarm outputs will open

when the alarm connected to that output is active.

If using either of the

two latch circuit outputs, you must select normally-open operation.

select normally-open operation, place the jumper plug over the two pins

closest to the side labeled “OPEN.” To select normally-closed operation,

place the jumper plug over the two pins closest to the side labeled

“CLOSED.”

ETTING

UMPER

✦

Setting the ENABLE switch

Make sure the ENABLE switch is set to the “ON” position. Otherwise,

the outputs will remain open.

ENABLE S

WITCH

UMPER

IRES NOT SHOWN)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Davis Alarm Output Module Manual de usuario Pagina 10