DAVIS Weather Talker Especificaciones descargar pdf (Pagina 179)

Weather Display Software Hints & Tips

179

rain in detail screen (and same applies for rain for each day of the last 7 days. When

setting/resetting there, the changes only apply to that data on that screen. To correct rain

totals under view, averages/extremes you need to change the last rain total for the day (i.e.

the last entry just before the daily rain total is reset) in the log file for the appropriate

month.

If you have lost your rain totals, then you should be able to find the last good rain total in

the log file.

Note that you can restore the log file for a month if it is bad, but the graph data is still

available for that month (under Graph history), by using the action Convert log files to

graphs, but select convert graph files to log files, and then make sure the correct graph

data file is selected (for example month102005.inf for October 2005), and then click

Convert. Wait for the Finished alert.

FAQ: Graphs show spikes and when the mouse rolls over

the spikes, abnormal readings appear

This appears most often with the dew point or windchill graph lines. The problem is

display-only issue due to an out of range graphing error. The actual data is not affected.

The solution is to extend the graphing range. Either use the lift/lower buttons in the Setup,

Graph Setup, or in the Graph Setup, change the graph ranges to prevent the spikes.

FAQ: COM port error

This often results because another software application is using the same COM port.

Possible conflicting devices include PDA synchronization applications or bluetooth cell

phone synchronization programs, etc.

Make sure no other software is accessing the COM port, especially other weather station

software applications (for example, Heavy Weather with La Crosse weather stations). Also

note that Microsoft Windows can swap COM port numbers.

If you are unable to resolve the COM port failure, you might be able to use a USB to serial

adaptor, or a serial port PCI card. Windows Device Manager will identify the assigned COM

ports. To access Windows Device Manager, do the following:

1. €Click Start, and then click Control Panel.

1. €Double-click System.

1. €On the Hardware tab, click Device Manager.

FAQ: La Crosse 2010/ 7000/ 2200/ 2500 type station

If no data is coming from the separate WS2010-15 data loggerl.

After inserting the batteries, you need to wait 20 minutes before any software should

access the data logger. Also it's a good idea to place the data logger away from the PC, and

put RF baluns clamps around the serial cable. Note that Weather Display gets the data

every 3 minutes or 5 minutes, depending on the station type.

Note, you can now use the newer La Crosse 3600 with Weather Display without the need to

run Heavy Weather, thanks to 3rd party software developed by Sandere of Denmark.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 190 191

Sin comentarios

DAVIS Weather Talker Especificaciones Pagina 179