DAVIS Wireless Repeater 7625 Manual de instalación descargar pdf (Pagina 10)

Page 10 Wireless Temperature/Humidity Station

5. Set the switch to the ON position using a ball-point pen or paper clip. When in test

mode, an LED indicator light flashes each time the station transmits:

• The LED will immediately flash once to show that the light itself functions.

• Then it will flash each time the transmitter broadcasts a signal, which

should be every 10 seconds.

6. If the LED flashes only once and then remains dark, there is a problem with the

transmitter. Refer to Troubleshooting on page 17.

7. If the LED flashes repeatedly but your console isn’t picking up a signal anywhere

in the room, it could be related to one of the following causes:

• The ID switches were not correctly set on the transmitter.

• Review the procedure on page 8.

• The station ID was not correctly set on the console/receiver.

• Review the procedure on page 9.

• Reception is being disrupted by RF (radio frequency) interference.

• There is a problem with the console/receiver.

• Refer to Troubleshooting, page 17.

Note:Remember to set the Test switch OFF when you’re finished testing wireless trans-

mission. If it is left ON, the blinking LED will significantly reduce battery life.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Sin comentarios

DAVIS Wireless Repeater 7625 Manual de instalación Pagina 10